4 flashes per second = iLO manual soft reboot sequence initiated.1 flash per second = Remote management or firmware upgrade in progress.Off = One or more of the following conditions exists: Ilo 2 license activation keygen serial number#Node serial number and iLO label pull tab Ilo 2 license activation keygen install#For example, it is possible to install in a chassis two 1U nodes and one 2U node. NOTE: The chassis supports the combination of 1U and 2U nodes. † If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status. ** Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the front I/O cable is disconnected. For more information, see "Power fault LEDs" in the HPE Apollo 2000 System User Guide. * When the LEDs described in this table flash simultaneously, a power fault has occurred.
0 Comments
Leave a Reply. |
AuthorChris ArchivesCategories |